||The drive motor
||Mterial of the coil
||GI AND PPGI
||220V 50Hz 3phases
||0.3 - 0.6 mm
Steel tile press automatic control system
1. Inverter controls the host's positive and negative running, and its speed can be controlled by the high-speed/low-speed switch on the panel. Always set the speed switch to high speed in automatic operation.
2. The oil pump switch is used to control the start and stop of the oil pump. Automatically start the oil pump to provide pressure for the hydraulic system. The forward and backward movement of the oil pump is controlled by the inverter to control the positive and negative running of the main engine. Its speed can be controlled by the high-speed/low-speed switch on the panel. Always set the speed switch to high speed in automatic operation.
3. The oil pump switch is used to control the start and stop of the oil pump. Before starting operation, turn on the oil pump to provide pressure for the hydraulic system. After the oil pump is running, pay attention to whether the pump running direction is consistent with the direction of the arrow. If not, change any three of the three phases in the pump motor.
4. The lower cut and return buttons control the operation of the cutter. If you press the cut, return button are invalid, generally should consider whether the oil level of the hydraulic tank is too low, should be no tank to add hydraulic oil. In addition, during the cutting and returning of the cutter, the limit switch operation in front of the cutter will automatically stop.
Q & A
What does the single pulse length of the tile press mean and what does it do? Why is my machine measuring length and display length different?
If the setting value is not changed, the size of the plate produced many times is the same (do not try to intervene manually). The pulse coefficient can be adjusted.
If the size of each plate is different:
1. Counter, the wheels are not installed, there are thrown and skid and dangle.
2. If there is no problem checking "Problem 1", the counter may be damaged.
Detection method: Remove the counter, turn the hand 10 times, check the value, and record the value.
What is the reason why the automatic steel tile cutter cannot lift after being cut off?
1 See the oil pump filter is plugged
2 See if the oil pump and motor connection keys are broken.
3 The solenoid valve is stuck and does not change direction.
About color steel tile cutter cutting fault and solution:
1. The knife keeps going down and the pump is blocked:
(1) The adjustment of the lower limit is improper or the switch is damaged.
(2) The solenoid valve is stuck. Turn off the oil pump, and press the knife to cut off the knife. When you hear the “click” sound, turn on the pump to raise the knife to the upper limit position.
2 The knife keeps going up and the pump is blocked:
(1) The upper limit is improperly adjusted or the switch is damaged. .
(2) K1 and K2 are reversed.
(3) The solenoid valve is stuck. Turn off the oil pump and press the knife to cut off the knife. When you hear the sound of “click”, turn on the pump and raise the knife to the upper limit position.
if you need contact us ,we can provide you best design and product .